Hi, sharing with you a fun card...

 ...Daffodils and Hyacinths.

Product list for the Heartfelt Creations products and other products used for this card:

HCDP1-2124 Delightful Daffodil and Butterfly paper collection

HCPC-3943 Delightful Daffodil and Butterfly cling

HCD1-7341 Delightful Daffodil and Butterfly cling

HCPC-3944 Delightful Daffodil and Hyacinth cling

HCD1-7342 Delightful Daffodil and Hyacinth cling

HCPC-3945 Delightful Daffodil Spray cling

HCD1-7346  Delightful Daffodil Spray die

HCD1-7228 Lacy Diamond die set

HCPC-3930 Elegant Gateway Sentiments cling

HCPP1-468 Deluxe Flower Shaping paper pack of 50

HCST1-401  Deluxe Flower Shaping Kit.

RAHT Heat It Craft Tool

DDOTS-Double sided 3D  foam dots

RACP451-Ranger Archival Ink- Coffee

RACP505 -Ranger Archival Ink- Sepia

173842 Scor-pal measuring and scoring board

18002 Rajni Chawla’s Vellum -10 sheets

159723 Designer Dries Clear Adhesive

409311 Color In Watercolor Brush-fine

 OTHER PRODUCTS USED: Inks: Spectrum Noir: Harmony Ink Grasshopper. Spectrum Aqua blend pencils: Daffodil: Primrose, Wheat, Sunshine, Strawberry. Leaves: Pesto Green, Oregano. Hyacinths: Pesto Green, Coral. Flowers: Strawberry. Butterfly: Asphalt, Sunshine, Bison, Umber. OTHER: Diamond stickles, Double sided tape, Double sided 3D foam tape, Inking Tool.

INSTRUCTIONS: This card when finished and folded flat measures 8“ x 6. 1/8“

Using a sheet of white card stock cut to 12“ x 6. 1 /8“. At one end make folds at  2“ and 4“ flip to the other end and do the same. Fold the fold lines to a hill and valley folds. Taking the sheet found in the paper collection with the checks printed and cut matting for each panel. Cutting these just a little smaller than the card base. Adhere to the card base. Taking the white card stock make a bridge for the card front, cut this to 2“x 8“ mat this also the same as the card front. Adhere across the card front at both the 2“ panels so when folded to one side it will sit flat. Taking the same paper design, cut the diamond frame using the die in the Lacy Diamond frame set. Make folds each end of this diamond frame, you will need 4 “ for the card bridge and the rest for the folds. Adhere the folds to the sides of the card to form a bridge.

Make the embellishments by stamping, die cutting and coloring the following: 2x Hyacinth clusters, 3x large single Hyacinths, 2x Butterflies and butterfly extra wings from vellum, 2x Daffodil with buds, 1x single Daffodil, 3x Flower clusters.

Color the elements by using the water color pencils listed in the product list and trim as needed when adhering to the card front as seen in the photo. Flower clusters across the card bridge and two butterflies. Daffodils adhered to the diamond frame, the Hyacinths adhered above the bridge on the panels each side of the card front.

The sentiment is stamped on a strip of card stock trimmed to at least 5“ . You will need 4“ for the width of the card front, the rest is folded at each end and then adhered to the sides the same as the diamond frame.

To finish the card, apply the diamond stickles to the Daffodils and butterflies.

This was a fun card to make so I hope you will give it a try.

I am so happy to share this with you, have a happy scrappy week, 

till then inky hugs

oxo